Unitech MS840 Instrukcja Użytkownika Pobierz pdf (Strona 24)

7. After you finish in scanning the pin code, scan the barcode as shown below:

CR($M)

8. When the pairing is successful, the scanner LED is off and has a short beep.

The scanner will operate as HID (keyboard) towards host.

Note: Scanning the DLE($P) will erase the previous entered link keys.

DLE($P)

Change between Cradle Mode and Cradle-less Mode

You may make the scanner change between cradle mode and cradle-less mode.

For example, if your scanner operates currently in cradle-less mode and you want

to change the existing mode of the scanner to cradle mode, then scan the Cradle

Mode barcode as shown below:

Cradle Mode

To determine whether your scanner mode is successfully changed, press the Page

button on the cradle; your scanner will have 2 short beeps when you press the

Page button.

For example, if your scanner operates currently in cradle mode and you want to

change the existing mode of the scanner to cradle-less mode, then scan the

Cradle-less Mode barcode as shown below:

Cradle-less Mode

Whenever the scanner enters cradle-less mode, you must pair the scanner with

your PC following step 3 through step 8 at the section called ―Cradle-less Mode

(without SCM Support)‖.

Note: When you successfully connected in Cradle and/or Crade-less, both

addresses are memorized in the scanner. To completely disconnect the

scanner;

1.Scan the Cradle Mode barcode, scan the Delete Address barcode,

2.Scan the Cradle-less Mode barcode, scan the Delete Address barcode

Delete BT Address

Delete Address

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Brak uwag

Unitech MS840 Instrukcja Użytkownika Strona 24